andrzej wita
More ideas from andrzej
This is a tool for adjusting your cutters to the rotational axis of your lathe.  This will help to prevent breakage from facing with a tool set too high, or poor surface finish with the tool set too low, or too high.

This is a tool for adjusting your cutters to the rotational axis of your lathe. This will help to prevent breakage from facing with a tool set too high, or poor surface finish with the tool set too low, or too high.

Modified Tool Holder by jjr2001 -- Here are a few of my favorite insert tool bits for the lathe: The first two on the left are shop made using 3/8" 1018 steel. Nothing special except that I like to put an insert on each end of the tool blank. With that config I can turn to a shoulder either left or right depending on the tool and then just remove and replace the tool holder on the 90 degree side of the tool post (parallel with bed) and the same tool (opposite end) will face the end of the...

Modified Tool Holder by jjr2001 -- Here are a few of my favorite insert tool bits for the lathe: The first two on the left are shop made using 3/8" 1018 steel. Nothing special except that I like to put an insert on each end of the tool blank. With that config I can turn to a shoulder either left or right depending on the tool and then just remove and replace the tool holder on the 90 degree side of the tool post (parallel with bed) and the same tool (opposite end) will face the end of the...

DIY 5 axis big CNC Router Head/Head-n4yus-jpg

First, sorry for bad English. Want to introduce my latest project - 5 axis CNC router with rotary head.

cnc vertical mill build log ( pics )

Yo , I needed a mill . liked the PCNC 1100 from tormach , but is expensive .