Gear train

Collection by Paul Doughty

126 
Pins
Paul Doughty
Squareness comparator I finished building today. I was planning to use 1/2” steel ball bearings for the feet and face but didn’t I didn’t have any in stock. Impatience caused me to improvise! I put a slight radius on some steel rod with my radius turning tool and sanded with progressively finer grit until I got the finish I wanted, then parted off at 1/2”. Reamed holes at .499” then discovered the stock I used is slightly undersized anyways, so had to cement the ...

Mini Machining Mayhem

Join me on my adventure through manual machining and turning on a Craftex CX600 benchtop mill and a Craftex CX704 (Sieg C2) 7x12 mini lathe.

Picture

Collet Holding Block

Picture

Collet Holding Block

Picture
Gear TrainMetal Working ToolsWorkshopTools

Collet Holding Block

Picture

Collet Holding Block

Picture

Collet Holding Block

Picture

Collet Holding Block

Picture

Collet Holding Block

Picture

Collet Holding Block

Picture

Collet Holding Block

Picture

Collet Holding Block

Picture

Collet Holding Block

Picture

Collet Holding Block

Picture

Collet Holding Block