Marcin Benbenkowski
Więcej pomysłów od użytkownika Marcin
From Polly Infatuated, 2011-05-17: this time I was inspired by the leafy pattern on the Orla Kiely duvet, with the right kind of plastic stuff, and one template (cut out and repeated 28 times) this was the result!    I made slightly longer pieces for the middle ring and shorter ones for the outside. Et voila!

From Polly Infatuated, 2011-05-17: this time I was inspired by the leafy pattern on the Orla Kiely duvet, with the right kind of plastic stuff, and one template (cut out and repeated 28 times) this was the result! I made slightly longer pieces for the middle ring and shorter ones for the outside. Et voila!

Tornado (TeaLight Holder) | 3dshare

Tornado (TeaLight Holder) | 3dshare

Apresentando o Extraordinário Jason Edmiston | Abduzeedo Design Inspiration & Tutorials

Apresentando o Extraordinário Jason Edmiston | Abduzeedo Design Inspiration & Tutorials

#UrbanMenOutfits

#UrbanMenOutfits

Bem Legaus!: Moai de gadgets

Bem Legaus!: Moai de gadgets

5b1b5fd15dfb646847e8313b8c021f6b.jpg 594×2,541 pixels

5b1b5fd15dfb646847e8313b8c021f6b.jpg 594×2,541 pixels

Selassi 3D printed lattice bowl. | Fabneo - an online boutique for 3D printed jewelry, art  lighting on http://www.fabneo.com remember to subscribe on youtube - Original post: http://pinterest.com/pin/565694403165033431/

Selassi 3D printed lattice bowl. | Fabneo - an online boutique for 3D printed jewelry, art lighting on http://www.fabneo.com remember to subscribe on youtube - Original post: http://pinterest.com/pin/565694403165033431/

designTun | Acessórios Contemporâneos para o Corpo

designTun | Acessórios Contemporâneos para o Corpo

Geometric Coasters; set of four handmade felt coasters. $38

Geometric Coasters; set of four handmade felt coasters. $38

I have been literally thinking a bit "outside the box" this weekend as I design and make a full enclosure for my 3D printer. Wood rods that mate into custom designed and printed bulkheads make up the perimeters and acrylic panels close off all sides to keep the heat and noise inside. A few fans will be added in strategic places if I need them along with a hinged access door secured by hidden magnets. LED light mounts will also be added in to give the whole presentation a cool "glow" for…

I have been literally thinking a bit "outside the box" this weekend as I design and make a full enclosure for my 3D printer. Wood rods that mate into custom designed and printed bulkheads make up the perimeters and acrylic panels close off all sides to keep the heat and noise inside. A few fans will be added in strategic places if I need them along with a hinged access door secured by hidden magnets. LED light mounts will also be added in to give the whole presentation a cool "glow" for…